Management of electric screw driver
Torque Meter @DI-9M-8/08
DI-9 series is most suitable for checking and controlling the torque of
Electric Screwdriver and Torque Driver.

Yes-no decision conditions etc. can save five channels.
.. A channel is only changed even if bolting conditions change.
It is not necessary to reset up a maximum value and a minimum value one by one like former.


The best for everyday check of an electric driver
Wide measurement range (0 - 8000digit)
Can measure without inversion Rolling-back work efficiently by OW joint (PAT.P).
Change of Measurement Unit Can be Performed
Data Output is USB Form (B Type).
Memory Data are 800 Affairs
Real-time Output is Every 1 / 180 Seconds.

Specification DI-9M-8 DI-9M-08
Measuring range 0.020-8 Nm 2.0-800 mNm

0.20`80 kgfEcm

0.020`8 kgfEcm
0.20`70 lbfEin 0.020`7 lbfEin
Accuracy   }0.5%  (499 digit or less  }3digit)
Display The 4 figures digital display of LCD
The measurement direction CW-CCW (right and left)
Zero return by one touch Return to zero by pressing clear button.
Measurement   Mode

Track , P-P(peak to peak) , P-D(Peak-Down) , C(Real-time Output)

High and low limits judging function

High and low value are measurement within the limits, and can be set up.

Real-time Output

Load torque value is outputted every about1/ 180 second.

The Maximum, the minimum, and the average value display

The maximum, the minimum value, and average value of the saved data

Data Output ASCII format (baud rate 19200)
Auto power save 10 minutes no use, automatically switch off.
Power supply Ni-Cd chargeable battery 1.2V ~ 5cells 700mAh
Charging time About 3hours
Continuous working time About 12hours
clearance It is a display clearance in set-up time.   (0.1 - 3.0 sec)
Socket size 20mm/  9.5mm
Dimension / Weight W:160~D:125~H:55 / About 1kg
Recommend buffer accessories Measuring joint
Measuring joint
Cube (with a 5th page screw hole)@20x20x20
@(M2.6/M3/M4/M5/M6 Tap processing)
AC/DC adaptor
Carrying case
An inspection report, a proofreading certificate, a traceability system figure

Do not use for measurement of impact tool.Do not apply more than the specified torque.

OW joint   Since our company developed the buffer
    with little influence of fricative,
    stable measurement could be performed

   Moreover ,it does not need to reverse-rotate
    at the time of  measurement,
    and work efficiency  improved.
Specification Type
OW-025 OW-10 OW-20 OW-60
Measuring range   Nm 0.25 1 2 6
Mechanical life   itimesj 10,000 8,000 5,000 5,000
(screw part)
M2.6 cross
recess screw
M3 cross
recess screw
M4 cross
recess screw
M6 cross
recess screw
The standard screw is cross recess screw
but they may be altered as necessary
Outside diameter 28 32 32 38
Height 44 51 51 69
hnstallation 20square ~4(t)

E-mail back Product list