CEDAR

Screw tightening control
œ DIGITAL TORQUE DRIVER @DID-05/4
@
Yes-no decision conditions etc. can save five channels.
.. A channel is only changed even if bolting conditions change.
It is not necessary to reset up a maximum value and a minimum value one by one like former.



*The torque screwdriver is Ergonomic and light weight, yet ruggedly constructed
*Available in: lb-in, kg-cm and N-m (mN-mj
*Peak, Real Time and Peak Down measuring mode (selectable)
*800 data memory.
*Programmable High and Low set points with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing
*Programmable screw tightening counter
*Programmable Auto Zero function resets unit to zero for easy operation
*Both CW and CCW operation
*ASCII format output(USB)
*Runs on internal Ni-MH batteries (for 12 hours) Auto shut-off after 10 min. of non-use
* AC charger and carrying case included.
Specification DID-05 DID-4
Measuring range
2.0 - 500 mN-m 0.020 - 4 N-m
0.020`5 kgf-cm 0.20`40 kgf-cm
0.020`4.5 lbf-in 0.20`35 lbf-in
Accuracy } 0.5% (in case of reading 499 or less = last digit +/- 3 reading)
Display The 4 figures digital display of LCD
The measurement direction CW-CCW (right and left)
Measuring
mode
P-P  Peak Holding Peak Load Value
T-R  Track Showing Real time torque value ( Used for Zero-Adjustment )
P-D  Peak down Holding Load Value at the moment to change from upward to downword
C Real-time output

Load torque value is outputted every about 1/ 160.

Decision
function
Setting of torque value Programmable High and Low setpoints with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing

The Maximum, the minimum, and the average value

The data number, the maximum, the minimum value, and the average value of memory data are displayed.

Data spec. Data transfer ASCII format (Baud rate : 19200)
When outputting data,the cable(USB miniB) is needed.
Data memory

800 data

A setup of the number of counts One to 99 count   (count in a direction with a bundle)
Power supply Ni-MH chargeable battery 1.2V~4cells 800mAh
Auto power save 10 minutes no use, automatically switch off.
Charging time From empty - less than 5hours
Continunous working time 12 hours
Bit /Socket part ƒΣ4 HEX6.35
Weight about 180g about 400g
Attachment Bit@i{j@”‚P@
For one-wey ~1@For fixation~1
Bit@i{j@”‚P@”‚Q
Bit holder@@
One way bit holder
Accessories
 (one piece each)
AC/DC Adaptor (Charger)
An inspection report, a proofreading certificate, a traceability system figure

DID-05 catalog @@DID-4 catalog
E-mail back Product list