CEDAR

Measurement of bolting machines
TORQUE TESTER @DIS-IPS
Yes-no decision conditions etc. can save five channels.
.. A channel is only changed even if bolting conditions change.
It is not necessary to reset up a maximum value and a minimum value one by one like former.


Performance check of an electric driver
Management of the bolting torque
 of an automatic line

Detection part is very a compact!
The best for measurement of an automatic line
OW join. it rewinds at and is needlessness.

Disply screen became large. It is very legible .It became large 1.5times.
Various attachments are attached. Measurement is possible,with a bit attached.

Yes-no decision@
Average calculation

Data storage is 800 affairs.
Data output at real time (every about 1/180 seconds).@
USB terminal data output


DIS-IPS
Specification DIS-IPS20C DIS-IPS5C
Measuring range 0.20`20 Nm
@@2.0`200 kgfEcm@@
2.0`174 lbfEin
0.020`5 Nm
0.20
`50 kgfEcm
0.20
`45 lbfEin
Accuracy }0.5%     (499 or less digit}3digit)
Display The 4 figures digital display of LCD
The measurement direction CW-CCW (right and left)
Measuring
mode
P-P  Peak Peak load value hold.
T-R  Track Indication of real time torque value.
P-D  Peak down Holding Load Value at the moment to change from upward to downword.
C Real-time output Load torque value is outputted every about1/ 180 second .
Decision
function
Setting of torque value A maximum and a minimum value are in a measuring range, and a setup is possible.
Can confirm the set value by the buzzer sound or LED.
Automatic Clearance Automatically clear the displayed value after certain time (0.5 - 3.0 sec,selectable at each 0.5 sec). Setting 0.0 sec for manual Zero clearance
One-touch-Zero Clearance Easy Zero-Adjustment with pressing CLEAR button
The Maximum, the minimum, and the average value The maximum, the minimum value, and average value of the saved data
Data spec. Data transfer ASCII format (Baud rate : 19200)
Data memory 800 data stored
Power supply Ni-Cd chargeable battery 1.2V~5cells @700mAh
Auto power save 10 minutes no use, automatically switch off.
Charging time From empty - about 3hours
Continunous working time 12 hours
Attachment fit mouth 20m@
Meter outside type dimension 100iWj~105iDj~40igj
Weight Meter part    520g
Attachment Fixed   Attachment@
20o@M4/M5/M6/M8
cube 20*20*20
(M2.6/3/4/5/6)
OW joint@OW-20 OW joint@OW-10
Accessories
 (one piece each)
AC/DC adaptor (Please choose AC adaptor out of 120V, and 230V.)
An inspection report, a proofreading certificate, a traceability system figure

OW joint is a measurement end at one-touch.
It binds tight and measurement is completed only by the work of a direction. Inversion operation like the former is unnecessary.Since the fit part with a bit is the screw head, where a bit is attached, it can be measured.By the conventional method, friction of a screw part had affected the measurement result.This joint has the structure where it is not influenced of fricative, and can manage torque stabilized over the long period of time

E-mail back Product list