|Rotation starting torque and the load torque under rotation|
|ROTATE TORQUE TESTER@NTS-6 Series|
|Measurement by the high precision gearmotor and the strain meter
While an output shaft carries out self-rotation, the load fluctuation of a solid of revolution is caught by the sensor.
The main features
- Peak, Real time and RGmode.(selectable)
- Programmable High and Low set points with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing.
- The type of series is five kinds.
It is adapted for various torque ranges (0.1 mN-m - 2 N-m).
- External input and output are also substantial.
An OK-NG output and data output External start signal input
- By RG mode (real-time output) loading, a torque wave is also simply with a personal computer.
(at the time of Track)
|2 mNEm@or Less@}3dijit||0.2 NEm@or Less@}3dijit|
(at the time of no-load)
|Display||The 4 figures digital display of LCD|
|The measurement direction||CW-CCW Possible (right and left) It rotates by the motor.|
|Peak operation mode (PP):
Display the maximum under measurement .
|Truck mode (GO):
Always display the load torque which has started.
|RG mode (PD):
Carry out the data output of the load torque every 1/ 87 seconds.
|Measurement start time||Time after beginning rotation until it starts measurement is set up
(0.1 - 1 second).
|Torque judging||It is in measuring range and a setup of a maximum value and a minimum value is possible.[ O.K.@I the Set point ] Lamp lighting : [ NG Outside the Set point ] Error buzzer|
|External input and output||Signal
output (open collector): O.K., NG
Data output: ASCII Format (baud rate9600), External start switch input
|bit size||Σ 4||HEX6.35|
|Outside size indicator||165iWj~110iDj~58iHj|
|Outside size detector||Σ28~155||Σ37~195||Σ40~235|
|Inspection report, Proofreading certificate, Traceability system figure|